[Q] MaxFu_HydraCoreNirvana_n3.JBT_STD.zip

Hi All,

I'm newly registered as I have problem in using HydraCoreNirvana Kernel.

I was using ZSLPN ICS Stock ROM with PhilZ-cwm6-ZSLPN-OZS-v2.7 Kernel.
A few days ago, I booted into CWM (Power + Up + Home) to flash MaxFu_HydraCoreNirana_n3_std.zip kernel.
HydraCore Kernel is working fine except that this kernel uses a lot of battery according to the
battery monitor. I keep using it for 3 days to make sure the whole system is stable after flashing a new kernel
but it is still consuming a lot of power.

Today, I boot into CWM (Power + Up + Home) to flash back the PhilZ-cwm6-ZSLPN-OZS-v2.7.zip kernel.
After flashing, I select reboot system, the "Galaxy Note N-7000" shows up and then black screen, i.e. without
the boot animation screen. I wait for a long time but still black screen. I tried to power up serveral times but same
thing happen. I then boot into CWM (Power + Up + Home), I can see PhilZ CWM so the PhilZ kernel should be flashed.
I then use this PhilZ CWM to flash Hydra kernel again and then reboot system. It can boot up.

I then try to boot into CWM to flash PhilZ kernel again, same problem. Now I flash back to MaxFU_HydraCoreNirana Kernel.

What's wrong with my procedures? Any idea? Now, I'm afraid to flash any other kernel as I am afraid I cannot flash
back to MaxFu Kernel and that will brick my phone.

Please help. Thank you so much.

I cannot post in Max_FU kernel thread as I am new here and not allowed to post there.
http://forum.xda-developers.com/show....php?t=2053084
Thanks.